0151 476 1462
Inside a loft being converted: a new timber dormer frame with white windows fitted, bare brick side walls and a radiator
Loft room with a new dormer frame, white windows fitted, bare brick side walls and a radiator below

Loft conversions in Liverpool & Merseyside: one team for the roof and the loft

Loft conversions in Liverpool, Sefton and Knowsley are carried out by Crown Roofing Solutions. This page explains whether your loft can be converted, the main types, the rules that apply and how the job runs.

Updated

Short answer

Many Liverpool lofts can be converted if there's about 2.2 m of height under the ridge and room for a proper staircase. Tell us what you're planning, the builder visits to look at the house and loft, confirms what the project needs (engineer, planning or a certificate, building control, party wall), and a free written quote follows.

Can my loft be converted? Head height, roof structure and stairs

Can I convert my loft into a bedroom? Usually yes, if three things work: enough head height, a roof structure that can be opened up or strengthened, and space for a staircase that meets the rules. A builder can only confirm this after looking at the loft in person.

Head height. Measure from the top of the ceiling joists to the underside of the ridge timber at the highest point. The usual guide is about 2.2 m. There is no legal minimum ceiling height for a loft room in the Building Regulations, but below roughly 2.2 m there's too little standing room once a new floor and insulation go in. If the roof is too low, the options are to lower the ceilings below (costly and messy) or raise the roof, which almost always needs planning permission.

Roof structure. Most Victorian and Edwardian terraces in Walton, Anfield, Bootle and Wavertree, and most 1930s semis, have cut-timber roofs: rafters supported on purlins. These are the easiest to convert. Houses built from the 1960s on usually have trussed rafters, the W-shaped timbers that fill the loft. A truss roof can be converted, but the trusses can't simply be cut out; a structural engineer designs new support, usually steel beams (RSJs) and new floor joists, before any timber is removed.

Stairs. The new stair usually lands over the existing one. It needs enough headroom over the steps (see the building regulations section below), which is often what decides where the dormer goes.

  • Steel beams: most conversions need some steel, to carry the new floor, the dormer or a new ridge. Sizes are set by the engineer's calculations, not by eye.
  • Loft conversion without steel: sometimes possible on a small roof-light conversion with a cut-timber roof, but only the engineer can say.
  • Low-pitch or shallow roofs: a rear dormer can win back height across most of the floor, even when the pitch is shallow.
  • Raising the roof or lowering ceilings: both are possible but add a lot to the cost; raising the roof needs planning permission.
Inside a loft with the roof removed to daylight, a large timber beam across the top and bare plaster walls around
Loft with the roof opened up to daylight and a large timber beam across the top

Loft conversion types

There are four main types of loft conversion, and the right one depends on the shape of the roof and the space you need. On Liverpool terraces the rear dormer is the most common.

  • Roof-light (Velux) conversion: windows set into the existing roof slope, with no change to its shape. The least structural work, but only suits lofts that already have good height.
  • Rear dormer: a box-shaped extension that rises from the back slope, giving near full-height space. Often allowed under permitted development on houses.
  • L-shaped dormer: on Victorian and Edwardian terraces with a back outrigger, a dormer on the main roof joins a second one over the outrigger, which can make room for two bedrooms or a bedroom and shower room.
  • Hip-to-gable: on a hipped semi or detached house (common on 1930s semis), the sloping side is built up into a vertical gable wall, often with a rear dormer as well.
  • Mansard: the back slope is rebuilt almost vertical with a flat top. It gives the most space but usually needs planning permission.

Permitted development. Many loft conversions on houses don't need planning permission. Under permitted development the extra roof volume can be up to 40 m³ on a terraced house and 50 m³ on a semi-detached or detached house, including any earlier roof additions. The work can't go higher than the existing ridge, can't extend beyond the front roof slope facing a road, must use materials similar in appearance, and can't include balconies. Side-facing windows must be obscure-glazed and fixed shut unless the opening part is more than 1.7 m above the floor. Dormers should normally be set back about 20 cm from the eaves.

Permitted development doesn't apply to flats or maisonettes, and it's restricted in conservation areas and where the council has made an Article 4 direction. A loft extension with a balcony, a front dormer or a raised roof normally needs planning permission. If you're not sure, check with your council (Liverpool, Sefton or Knowsley). A lawful development certificate from the council confirms in writing that your plans are permitted development, which helps when you sell.

Inside a new dormer shell before plastering: windows fitted into the frame, bare timber floorboards and brick walls around
New dormer shell before plastering, with windows fitted and bare timber boards on the floor

Building regulations: fire safety, stairs and insulation

Every loft conversion that creates a room needs Building Regulations approval, even when it doesn't need planning permission. The main parts are A (structure), B (fire safety), K (stairs) and L (insulation and energy). Approval comes from the council's building control team or a registered building control approver, and you get a completion certificate at the end.

  • Part A, structure: the engineer's calculations for the floor joists, steel beams and any altered roof timbers.
  • Part B, fire safety: adding a storey to a two-storey house means the stair must become a protected escape route down to an outside door. Usually that means fire doors to the habitable rooms off the stair, and mains-powered, interlinked smoke alarms on every floor. Approved Document B sets out the details.
  • Part K, stairs: a private stair can be no steeper than 42°, with risers of no more than 220 mm. Headroom is normally 2.0 m; for loft conversions Approved Document K accepts 1.9 m at the centre of the stair and 1.8 m at the side where there isn't room for more.
  • Space-saving stairs: alternating-tread stairs or a fixed ladder are only allowed where there's no space for a normal stair, and only for one habitable room (plus an en suite). Retractable loft ladders aren't acceptable for a habitable room.
  • Part L, insulation: the roof slopes, dormer cheeks and walls must meet the U-values in Approved Document L. The thickness depends on the product: rigid PIR boards need far less depth than mineral wool. Ask for the U-value calculation rather than a thickness on its own.
  • Ventilation and bathrooms: an en suite needs an extractor fan under Approved Document F, and the roof needs ventilation to avoid condensation.

A loft "signed off as a playroom" or hobby room usually means it was never approved as a habitable room, often because of the stair or fire escape, so it shouldn't be used or sold as a bedroom. If a seller has no building regulations certificate for a loft, indemnity insurance only covers the risk of council action; it doesn't make the loft safe. For work done since November 1985 without approval, you can ask the council for a regularisation certificate, which may mean opening up parts of the work.

Loft room stripped back to bare brick and timber, with insulation boards fitted between the studs and a new window frame
Sloping loft wall stripped back to brick, with insulation boards fitted between the timber studs

How a loft conversion works, week by week

A loft conversion runs in two stages: getting the design and approvals in place, then the build. Here is how it works when you get in touch through this site.

  1. Tell us what you're planning: the type of house, what you want the loft for, and any photos or old plans you have.
  2. The builder visits to look at the house and loft: head height, the roof structure, where a stair could go and how the dormer would sit.
  3. They confirm whether the project is one they can take on, and what it needs: a structural engineer, planning permission or a lawful development certificate, building control, and a party wall notice where relevant.
  4. A written quote follows. It's free, and it should list what's included and what's left to you.

Not every loft or extension suits every builder. You'll be told at the visit if yours isn't one we can do.

Do you need an architect? Not always. Many loft conversions are drawn by a plans technician or architectural designer, with a structural engineer for the calculations. More complex designs, or homes in conservation areas, can benefit from an architect.

Party walls. On a terrace or semi, steel beams usually bear on the party wall, so the Party Wall etc. Act 1996 applies. You must serve notice on your neighbours at least two months before that work starts. They can agree in writing, or a party wall surveyor settles the details.

The build, as a rough guide. Scaffold goes up and the roof is opened, usually from the outside. Steels and floor joists go in, the dormer is framed and the roof is made weathertight. Then windows, insulation, wiring and plumbing, plasterboard, and finally the stair is cut through into the floor below, often one of the last jobs. Building control inspects at set stages. Many families stay in the house throughout. Ask for a written programme with your quote, because the length depends on the type and size of conversion.

Room stripped out for a new dormer: rubble and debris across the floor, with a worker crouched in the wall opening
Room stripped out for a new dormer, with rubble on the floor and a worker in the wall opening

Choosing a loft conversion company

Whoever you choose, the same questions sort good loft conversion companies from bad ones. Ask each builder these, and get the answers in writing.

  • Who draws the plans, and who is the structural engineer? Can I see the calculations?
  • Is it permitted development, or does it need planning permission? Who applies for the lawful development certificate or planning?
  • Who handles building control, and will I get a completion certificate at the end?
  • Who serves the party wall notices, and who pays the surveyors if a neighbour dissents?
  • What exactly does the quote include: scaffold, skip, stairs, fire doors, electrics, plumbing, plastering, decoration?
  • How are payments staged? Avoid paying a large sum up front.
  • What insurance do you hold, and what guarantee is offered? Ask for both in writing.
  • Who will be on site day to day, and who do I call with a problem?

Quotes are free and given in writing after the visit. Compare quotes line by line, not just on the total. Our guide to spotting a dodgy roofer covers warning signs that apply to any builder.

More questions about loft conversions

48 more questions homeowners ask, each linked straight to its answer.

Loft conversion types & designAll roofing questions

Questions people ask

How do I know if my loft is suitable for conversion?

Check the head height under the ridge (about 2.2 m is the usual guide), whether the roof has rafters and purlins or W-shaped trusses, and whether there's room for a stair above the existing one. A builder confirms it at a visit.

Can you convert a loft with roof trusses?

Yes, but the trusses can't just be cut out. A structural engineer designs new support, usually steel beams and new floor joists, and the roof is strengthened before any truss is altered.

Does a loft room need building regulations?

Yes. Turning a loft into a room needs Building Regulations approval for structure, fire safety, stairs and insulation, even if no planning permission is needed. You should get a completion certificate at the end.

Do I need planning permission for a loft conversion?

Often not. Many house loft conversions are permitted development, up to 40 m³ of extra roof space on a terrace and 50 m³ on a semi or detached house. Flats, conservation areas and front dormers are different, so check with your council.

Does a loft room need a window?

A habitable room needs natural light and ventilation, so in practice yes. A roof window or dormer window provides both. Whether a window is also needed for fire escape depends on the fire strategy agreed with building control.

How do you get stairs into a loft conversion?

The new stair is usually built above the existing one so the escape route stays in one protected stairwell. It needs about 1.9 m of headroom at the centre, which often decides where the dormer goes.

How long does a loft conversion take?

It depends on the type and size. A roof-light conversion is the quickest and a mansard the longest. Design and approvals often take longer than the build itself, so ask for a written programme with your quote.

Can you live in the house during a loft conversion?

Usually yes. Most of the work is done from the scaffold, and the stair is often one of the last things to be connected to the floor below, which keeps dust in the rest of the house down.

How do I check if a loft conversion has building regulations approval?

Ask the seller for the completion certificate, or ask the council's building control team, which keeps records of approved work. Work approved by a private building control approver is also registered with the council.

Is a loft conversion a good investment?

It can add space and usually adds value, but how much depends on the street and the finished layout. A local estate agent can tell you what an extra bedroom is worth in your area before you commit.

How much does a loft conversion cost in Liverpool?

It depends on the type, the size and how much steelwork is needed, so no honest builder can give a price without seeing the loft. Quotes are free and given in writing after the visit.

Do I need a party wall agreement for a loft conversion?

If you're in a terrace or semi and the steels bear on or cut into the shared wall, yes. You must serve notice at least two months before that work, under the Party Wall etc. Act 1996.

Book a free roof visit

  1. Tell us about the jobCall or send the form. A photo helps us understand it before we come out.
  2. We arrange a visitThe roofer comes to look at the roof in person, at a time that suits you.
  3. Written quote after the visitFree, with no obligation to go ahead.
Or call 0151 476 1462

We use your details only to reply about your roof, and pass them to the roofer who quotes. Privacy notice

Call 0151 476 1462

Cookie settings

Choose what this site may load. You can change this any time from the link in the footer. Full details

Necessary

Remembers your cookie choice. Always on, because the site needs it to respect your choice.

Video

Loads short job videos from Bunny.net when you press play. Bunny.net may set cookies to stream the video.

Maps

Shows our location on Google Maps. Google may set cookies when the map loads.

Analytics and advertising

Not used on this site.

None